ACUITY 217PM1 30 LED WALL PACK 120VPOLY

Intended use: The energy savings, long life and easy-to-install design of the TWP LED make it the smart choice for building-mounted doorway and pathway illumination for nearly any facility. Construction: Die-cast aluminum rear housing has an impact-resistant, UV-stabilized polycarbonate front housing and refractor that is fully gasketed. Modular design allows for ease of maintenance. The LED driver is mounted to the front casting to thermally isolate it from the light engine for low operating temperature and long life. Housing is completely sealed against moisture and environmental contaminants. Finish: Exterior parts are protected by a zinc-infused Super Durable TGIC thermoset powder coat finish that provides superior resistance to corrosion and weathering. A tightly controlled multi-stage process ensures a minimum 3 mils thickness for a finish that can withstand extreme climate changes without cracking or peeling. Available in textured and non-textured finishes. Optics: Protective polycarbonate lens covers the light engine’s precision-molded proprietary acrylic lenses. Light engines are available in 5000K (65 min. CRI) configurations. Electrical: Light engine(s) consist of 10 or 30 high-efficacy LEDs mounted to a metal-core circuit board and integral aluminum heat sink to maximize heat dissipation and promote long life (L94/100,000 hrs at 25°C). The electronic driver has a power factor of 90%, THD 20%, and a minimum 2.5 KV surge rating. When ordering the SPD option, a separate surge protection device is installed within the luminaire which meets a minimum Category C low operation (per ANSI/IEEE C62.41.2). Installation: Top 3/4” threaded wiring access. Back access through removable 3/4” knockout. Feed-thru wiring can be achieved by using a condulet tee. Mount on any flat, vertical surface. Listings: CSA certified to U.S. and Canadian standards. Rated for -40°C minimum ambient.